Use the confreg command and complete the instructions presented on the screen.
I've included some values that I'm not sure are correct. The following code will change the baud rate from 9600 to 38400: Code: Select all | TOGGLE FULL SIZE. Use a serial null modem cable (part#10-2020L) with Program Adaptor (part#95-05438L)to con- Select the appropriate menus on the left to change/verify settings. I recommend that you don’t change the baud rate With this, I can change the pairing pin, device name or baud, beside of sending AT commands or sending a string over the wireless bridge. Make sure to select the correct Arduino Board Setup. You can change the frequency and baud rate for tracking the OmniSTAR satellite by using the web user interface (WebUI).
If n=2, a baud rate of 1200 bps is selected.
To check/set the baud rate, use “Actisense NMEA Reader” (issued by Active Research Limited). But I am not able to communicate with the emb device as the maximum baud rate that can be set in Windows 7 device manager for this device is 128000. Specifies using IEEE 1394 as the debug connection type To change debugger settings for a startup entry, run the following command.
